|
UPDATE 04/09/09 : TCCs are in
stock right now and available at the online (36" & 42")
store.
TAC CARBINE/RIFLE CASE (TCC)
The ideal Tac Carbine/Rifle Case
designed and produced based on feedback from shooters from The High Road
forum and Chief Rob Haught. Our sincere thanks and appreciation goes to
each and everyone of them.
11/12/06 - Our sincere
thanks also goes out to the Marines of the 4th Recon Bn for adopting the
TCC as the carry case of choice.
This case was produced with no regards
to expense. We've put in the best of what we could possibly get our hands
on, in terms of material and hardware. We've had the prototype field tested
by a number of folks who've all indicated that this is a very impressive
case. The ability to attached any of your existing PALS related pouches was
a big hit.
Below are photos of
various setups from respective TCC owners! Thanks to all for allowing us to
show them off.
READ A REVIEW
OF IT IN THE APRIL 2005 ISSUE OF S.W.A.T
MAGAZINE
ATTN 3-GUNNERS : The 42"
length version of the TCC case is long and large enough to hold (for
example) a Remington 870 pump (or 11-87) and an M4 in the main compartment while
the rest of your accessories and required ammo can be stored in the outer
pocket using any PALS compatible pouches. Our PALS compatible pouches and
accessories will be available only in late December '05 (scroll to BOTTOM).
READ unbias and personal reviews
of this case online:
|
TAC CARBINE CASE
|
|
Produced in lengths of 30”, 36",
42" & 46" - Currently only in BLACK & COYOTE BROWN
|
|
PALS Webbing both on the insides of the main compartment and the
large outside pocket allows you to configure the mount and provides
sufficient space for you to attach any of your existing PALS related
pouches.
|
|
Height - The height of the case is such that you can mount a
fully loaded carbine/rifle, with optics / NVD and a 30-rounder, ready to
go
|
|
Length - These cases are produced with about an additional inch
or so in length since feedback we received indicated that most cases are
too tight a fit.
|
|
1000 Denier Cordura
|
|
Two Set of External D-Rings allow versatility of strap placement; shoulder carry
or quiver carry (rear)
|
|
Non-Slip Padded Strap
|
|
Heavy Duty Steel Hardware
& Webbing
|
|
#10 Coil Zippers & Pulls
|
|
Close Cell Foam with Plastic
Inserts - protective padding and the inserts prevent any
printing / signature of the carbine
|
|
30" - $179.95
36" - $189.95 (NSN #
1095015349355 )
42" - $199.95 (NSN #
1095015349354 )
46" - $209.95 (NSN #
1095015349356 )
You can purchase the TCC on our
online store HERE!
|
Part of tactical 3-gun setup
(above); additional PALS compatible pouches (below) that will available
late December (shown in khaki).
|
